Al2-Asi-Bd (Al2-14Mr-*, Al2-24Mr-* ); Introduction; External Dimensions - Mitsubishi AL2-10MR Manual Del Usuario

α
2 Simple Application Controllers
9.

AL2-ASI-BD (AL2-14MR-*, AL2-24MR-* )

The AL2-ASI-BD Actuator Sensor Interface board module is used in conjunction with
series controller for data communication over an Actuator Sensor Interface (AS-interface)
network.
Further information can be found in the
Caution
• Persons trained in the local and national electrical standards must replace the
AL2-ASI-BD.
• Turn off the power supply when you install or remove the AL2-ASI-BD.
• Replace the cover after removing the AL2-ASI-BD.
• Under no circumstances will Mitsubishi Electric be liable or responsible for any
consequential damage that may arise as a result of the installation or use of this
equipment.
9.1

Introduction

The AL2-ASI-BD connects onto the main unit of the
station for an AS-interface network (Input 4 points, Output 4 points). A maximum of 31 slaves
can be connected to form an AS-interface network. Power for the communication is supplied
over the AS-interface bus by the AS-interface power supply. The communication signal is
superimposed over the power supply on the AS-interface bus.
9.1.1

External Dimensions

Figure 9.1: External Dimensions
AL2-ASI-BD (AL2-14MR-*, AL2-24MR-* ) 9
α
2 Series Programming Manuals.
α
2 series controller, forming a slave
α
2
Unit: mm (inches)
ENG-44