Coil Surface Element; To Raise The Top For Cleaning; To Remove And Replace Oven Door - Sears Kenmore 790.4525 Serie Manual De Uso Y Cuidado

General Care & Cleaning

Coil Surface Element

To Remove and Replace Surface Elements and Drip Bowls
ATTENTION: Never leave lids on the coil elements as they could be permanently damaged if the coil is turned on by accident.
Prior to cleaning the coil elements make sure they are cold and that control knobs are turned to OFF

To Raise the Top for Cleaning

A rod swings up to support
the top for cleaning under-
neath.

To Remove and Replace Oven Door

To Remove the Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers. You may have to apply a little down-
ward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports. Keep pulling
the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge
levers.
To Replace the Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots. Open the door to the fully opened position.
2. Disengage the lock from the hinge levers on both sides.
Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.
3. Close the oven door.
The door is heavy. After removing door, lay it flat on the floor with the inside of the door facing down.
Lock in normal
position
Coil elements clean themselves when they are turned on.
Coil elements and drip bowls are removable and allow to clean the drip bowls.
To remove a coil element, push against the front edge and lift element up and out.
To clean by hand, wash the drip bowls in hot sudsy water. For hard to remove spots, use
nylon scrubber with soap. Rinse and dry will still warm.
Never immerse coil elements in water.
Be careful not to bend terminal ends when replacing elements after
cleaning.
1. Grasp the sides and lift from the front. A lift-up rod will support the top in its raised position.
Only lift the top high enough to allow the support rod to rest in place under the front of the
cooktop.
2. Clean underneath using a clean cloth and hot, soapy water.
3. To lower the top, lift the top slightly and lower the rod. Lower the range top down into the
range frame.
When lowering the lift-up range top, grasp the sides with fingertips only. Be
careful not to pinch fingers. DO NOT drop or bend the range top when raising or lowering. This
could damage the surface.
Lock engaged
for door removal
16
HINGE SLOT
Door removed
from the range