Automatic Buttonhole - Baby Lock A-Line Serie Guía De Referencia Rápida

1
4
•
•
2
1
2
3
4
5
50
All manuals and user guides at all-guides.com
3
5
•
* The size of buttonhole is automatically set by
* The button holder of the foot takes a button size
* Make a test buttonhole on a sample duplicating
* Place the button on the fabric sample and mark
A
B
C

• Automatic Buttonhole

Pattern selector:
1
2
Presser foot:
3
Thread tension: 1 - 5
4
Stitch length:
5 Stitch width: 5
placing the button in the automatic buttonhole
foot (R).
up to 2.5 cm (1´´) in diameter.
the fabric, interfacing and seams of the actual
garment.
the top and bottom to determine the position
of buttonhole.
1
Use interfacing on stretch and loosely woven
fabrics.
2 Turn the handwheel toward you to raise the
needle to its highest position.
Raise the presser foot lifter.
Select the pattern "
3
pattern selector dial.
* If the BH pattern is already selected, reset the
dial once according to the procedure in step
page 52).
4 Attach the automatic buttonhole foot (R).
Note: There should be no gap between the
slider and spring holder of the foot as
shown above.
Slider
A
There should be no gap
B
Spring holder
C
5
Pull the button holder to the back, and place
the button in it. Push back the button holder
toward you as far as it will go.
Pull the buttonhole lever downward as far as it
will go.
Automatic BH foot
( 0.25 - 1)
" by turning the
(on
12