Preparing The Awc; Preparing The Remote Control - Stel TIG μP 203H-353H AC/DC Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

ENGLISH

TIG µP 203H-353H AC/DC

COD. 6902500070

4.5 PREPARING THE A.W.C.

INVERTER GENERATOR

The inverter generator TIG µP 203-353H AC/DC is not provided with the

coupling for connection to the A.W.C. group, but if you decide to install it the

machine is already equipped to receive it.

To fit it, proceed as follows:

1) Remove the plate A that covers the hole on which the

coupling is to be positioned.

2) Connect the pin located inside the machine to the coupling

(Cod. 607150000L) .

3) Fix the coupling to the machine.

4.6 PREPARING THE REMOTE/PEDAL CONTROL

TIG µP 203-353H AC/DC inverter generators are provided with a special coupling

(ref.13 page 9) which allows the connection of the remote control or of the pedal

control (CAD). When the REM ON selection button (ref.6 page 9) is pressed

quickly, remote control mode is switched on ; the REM ON led (ref.6A page 9)

lights up. The welding current varies from a minimum (4A) to a maximum which

may be set on the machine with the regulating encoder (ref.5 page 9). It is also

possible to choose the starting current by pressing the selection button REM ON

(ref.6 page 9): the starting current will blink on the display 21 and may be

regulated by means of the general encoder (ref.5 page 9).

To turn off the remote control function, hold down the REM ON button (ref.6 pag.9)

for more than 2 seconds

The remote / pedal control, allows regulation of the welding current without acting

directly on the generator.

STEL s.r.l. – Via del Progresso n° 59 – 36020

Loc. Castegnero (VICENZA) - ITALY

TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)

FAX +39 444 639641 – E-mail:stelgroup.com

http: www.stelgroup.it

TECHNICAL

DESCRIPTION