VOLTOMAT HEATING BH-117327.1 Manual De Instrucciones página 107

2) Press the button "
3) Press the button "
4) Press the button "
2. Button " " in the remote control:
1) Make sure the appliance is in standby mode. Press the
on/off button "
ventilator on. (A)
2) Press the function button "
the appliance will blow warm air. (B)
3) Press the function button "
switch to full power. The appliance will blow hot air. (C)
4) Press the function button "
5) Press the on/off button "
TIMER
1) When the appliance is working, press the timer button "
The set working time will flash a few seconds, then the display panel will shows the previous setting and
the timer icon "
2) When the appliance is in standby mode, press the timer button "
00-12 hours. The display shows the set hours and the icon "
appliance starts automatically when the timer is over. The standard temperature is 23°C (Note: it is not
possible to set the temperature using the buttons).
Note: The timer button "
appliance.
TEMPERATURE SETTING:
1. Switch the unit on by pressing the on/off button "
your desired temperature (between 10 °C and 49 °C); the standard setting is 23°C. Press button "OK" to
confirm the setting. The display shows the set temperature and the power.
2. When you set the temperature, the appliance will select the power required: full power (if the set
temperature is more than 2 °C higher than the ambient temperature) and low power (if the set
temperature is higher than the ambient temperature, but the difference value is less than or equal to
2 °C). Once the ambient temperature has reached the set temperature, the heating element will be
" again, the appliance will blow warm air. (B)
" a third time, the appliance will blow hot air. (C)
" a fourth time, the appliance will be off and back to standby mode.
" in the remote control to switch the
" to switch the heating on,
" again, the heating will
" a third time, the heating will be off; the appliance will blow cold air. (A)
" to turn off the appliance.
". The appliance will be off automatically when the timer is over.
" on the remote control works in the same way as the timer button on the
" to set the working time from 00-12 hours.
" and the timer starts counting down. The
", press the plus or minus button "
- 106 -
" to set a delayed start time from
/ " to set