VOLTOMAT HEATING BH-117327.1 Manual De Instrucciones página 109

Note:
1) The weekly program is continuous, which means that it returns to day 1 at the end of day 7. If that is not
what you want, you should turn the weekly program off.
2) To check the settings, press "DAY", "EDIT", "TIME/ON" then "TIME/OFF". The display will show the
settings.
3) The timer can only be set to hours, not minutes.
4) The stop time must always be later than the start time.
5) Your settings will be lost if the appliance is switched off by pressing the power switch, if there has been a
power cut or if the plug has been removed from the socket. Press button "SET" to check the day and time
and set them again if necessary.
SET OPEN WINDOW DETECTOR
1. Make sure the unit is switched on.
2. Press button "
and minus buttons "
3. When the open window detection is switched on, the appliance will switch off if the temperature in the
room drops by between 5 and 10 degrees within 10 minutes, and go to standby mode.
4. In this case, you can turn the appliance on again by pressing the on/off button "
" " again to turn the open window detection off. The icon "
unit returns to its previous settings.
5. If both the weekly programme and the open window detection are on, the open window detection will
only work while the appliance is switched on in the weekly program.
OVERHEATING PROTECTION
The overheating protection system switches the unit off if it gets too hot. Common reasons for this are that
the unit has been partially or completely covered, the intake/outlet are blocked or the unit has been placed
too close to a wall. If the overheating protection is activated and the unit switches off, the unit will start to
ventilate to get rid of the extra heat. In this case, the display does not change. Once the unit has cooled down,
it will return to its previous setting. We advise to switch the unit off using the remote control and to give it
enough time to cool down. Once you have removed the cause of the overheating, you can use the unit again
as normal. If you cannot find the cause of the overheating and the unit continues to overheat, you should turn
the unit off and return it for repair.
MAINTENANCE
Before you clean the unit, turn off the switch. Remove the plug from the socket and wait until the fan

heater cools down completely.
Use a damp cloth to wipe the heater housing.

Clean the air inlet / outlet grills frequently with a soft dry cloth.

Do not use detergents, abrasive cleaning liquids or chemicals (alcohol, gasoline etc.) to clean the

appliance.
Do not allow the interior to get wet as this could create a hazard.

To store away the heater, put the heater back into its original package and store it in a clean dry place.

"; the display shows icon "
/ " to choose your desired temperature.
". The standard temperature is 23 °C; you can press plus
" disappears from the display and the
- 108 -
". Press the button