VOLTOMAT HEATING BH-117327.1 Manual De Instrucciones página 108

switched off but the ventilator remains switched on for another 30 seconds; then the appliance will be in
standby mode. The appliance will switch on again if the room cools down to 2 °C below the set
temperature.
Note: To turn the thermostat off, press the function button "
unit will now work continuously. You no longer see the temperature on the display. If the appliance has been
running continuously for 12 hours, it will switch off automatically, cool down and return to standby.
DAY AND TIME SETTING
1. Press the set button "SET" once; the display will show the hour. Use the plus and minus buttons "
/ " to set the hour (from 0 to 23).
2. Press the set button "SET" again to set the minute. Use the plus and minus buttons "
number of minute (from 00 to 59).
3. Press the set button "SET" again to set the day; use the plus and minus buttons "
Monday = d1, Tuesday = d2, etc.
4. Finally, press the button "OK" to confirm the settings. The display will show the previous setting. Press the
set button "SET" to check the day and time.
WEEKLY PROGRAMME SETTING
1. Before set a weekly programme, you first need to set the date and time. Switch the unit on by pressing
the on/off button "
2. Press the program button "P"; icon "P" appears on the display.
3. Press button "DAY"; icon "d1" appears on the display. Press button "DAY" again to set the day: d1 =
Monday, d2 = Tuesday, etc.
4. Press button "EDIT"; icon "P1" (programme 1) on the display. A maximum of six programs can be set per
day: P1 to P6. Press "EDIT" again to go to P2, and so on.
5. Press button "TIME/ON" to set the start time; the display will show "00". Press "TIME/ON" to increase the
start time from 00 to 24.
6. Press button "TIME/OFF" to set the stop time; the display will show the start time (the start time you just
set). Press "TIME/OFF" to increase the stop time. The stop time must always be later than the start time.
If both times are the same, the unit will switch to standby mode.
7. Press the plus and minus buttons "
8. Finally, press button "OK" to confirm the setting.
9. Repeat steps 3 to 8 to set a weekly program of start and stop times, for 7 days and up to 6 programs per
day.
10. Follow the steps described above to change a setting. This will overwrite the previous values. Press the
button "OK" to confirm the setting.
11. To turn the weekly programme off, press the button "P" again. The icon "P" disappears from the display
and you leave the weekly programme. The unit returns to its previous settings.
".
/ " to set the required temperature.
" to select heating on low or full power. The
- 107 -
/ " to set the
/ " to set the day: