Cleaning And Maintenance; Troubleshooting - Concept VP4350 Manual De Instrucciones

EN
OPERATING INSTRUCTIONS
Assembling the vacuum cleaner
NOTICE
Always switch off the appliance and disconnect the charger from wall socket before assembling or removing accessories!
Accessories
1. Floor nozzle
*for VP4353, VP4354 only
2. Slot nozzle
This nozzle is used for vacuuming spaces which are hard to reach, such as radiators, slots, corners, bases, space
between the upholstery, etc.
3. Nozzle with a brush
This nozzle is used for vacuuming furniture, upholstery, books, lamps, etc.
4. PET brush
This brush is used for vacuuming animal fur directly on the animal (cat, dog).
5. Car nozzle
This nozzle is used for vacuuming spaces in cars which are not easily accessed by vacuum cleaners.
VP4353, VP4354 only
6. Head for vacuuming water
This head is used for vacuuming a smaller amount of water.
7. Head reducer
It is used to attach the PET brush and Car nozzle to the vacuum cleaner.
8. Bag for accessories
*for VP4353, VP4354 only
9. Cleaning brush for cleaning the HEPA filter
*for VP4353, VP4354 only
10. Charger
*for VP4353, VP4354 only
11. Charging station
*for VP4350, VP4351 and VP4352 only
12. Extension tube 2 pcs
*for VP4353, VP4354 only
Charging the battery
To prolong the life of the vacuum cleaner battery, follow these instructions:
• Do not leave the vacuum cleaner fully charged or completely discharged
for a long time.
• Prolonged discharged of the battery will result in loss of its capacity.
• Do not let the vacuum cleaner to be completely discharged.
• It is ideal to keep the capacity of the battery between 20 % - 80 %.
During charging, three LED lights next to the power button flash one by one.
The charging is complete when all three LED lights are continuously on.
Operating time at full charge of the battery is approximately 20 minutes.
Using the vacuum cleaner
NOTE
Before using the vacuum cleaner, make sure that the filters are correctly positioned and fixed.
1. Remove the vacuum cleaner from the charging base.
2. Press the On/Off switch to turn on the vacuum cleaner.
3. After you are done using it, press the On/Off switch again to turn it off.
Checking the fullness of the dust container
If the suction power of the vacuum cleaner is reduced or the dust container is full, empty it and clean the vacuum cleaner
filter. For the VP4353 and VP4354, you can use a cleaning brush (K) to clean the filters.
38
*for VP4352, VP4353, VP4354 only
*for VP4351, VP4353 and VP4354 only
*for VP4352,
*for VP4351, VP4352, VP4353 and VP4354 only
*for VP4350, VP4351 and VP4352 only
VP4350 | VP4351 | VP4352 | VP4353 | VP4354
Vacuuming water
The vacuum cleaner also allows you to vacuum a small amount of water. It is necessary to attach the head for vacuuming
liquids to the vacuum cleaner. However, the amount of water must not exceed the maximum level of dirt of the dust
container. This may cause clogging of filters and serious damage to the appliance. Empty the dust container before
vacuuming water. Never leave water in the container.
MAINTENANCE
It is recommended to empty the dust container and clean the vacuum cleaner filters after each use of the vacuum
cleaner.
Emptying the dust container
1. Disconnect the charger from the mains.
2. Hold the vacuum cleaner down with a dust container.
3. Press the latch to release the dust container.
4. Remove the water separator and empty the vacuum cleaner dust container.
5. Reverse the procedure to attach the water separator and the filter and put the dust container back.
Cleaning and replacing the permanent filter
The vacuum cleaner filter can be cleaned by mechanical tapping and cleaning with a soft brush. Heavily soiled filter can
be washed after this step and cleaned with a soft brush in lukewarm water without detergents.
It is important to let the wet parts dry thoroughly. A wet filter would be depleted by vacuuming! Do not use
a hair dryer for drying!
Note: Wet cleaning can cause more wear on the filter and thereby shortening its life.
• The filter should be cleaned or replaced with visible soiling or when the suction power of the vacuum cleaner drops.
Check it after each use of the vacuum cleaner.
• To avoid damaging the vacuum cleaner, do not use it without a properly fitted filter and water separator.
• You can purchase a suitable filter type from your dealer or order from the manufacturer.

CLEANING AND MAINTENANCE

Accessories and vacuum cleaner can be cleaned with a damp cloth.
Do not immerse the power cord or the charger in water or any other liquid.
Do not use aggressive substances such as solvents or abrasives for cleaning!

TROUBLESHOOTING

Problem
The motor is not working.
The battery is discharged.
Full or clogged dust
container.
Reduction of suction power.
The filter is clogged.
Operating time at full charge is
The battery life is over.
less than 1 minute.
The vacuum cleaner is warming Warming up of the vacuum cleaner during operation is normal, it is not
up. a malfunction.
VP4350 | VP4351 | VP4352 | VP4353 | VP4354
Cause Remedy
Charge the battery.
Empty and clean the dust container.
Clean or replace the filter.
Replace the battery with a new one.
Contact an authorized service centre.
EN
39