INSTALLING WELL APPLICATION
Shallow Well Application
Shallow well systems are identified by one pipe going to the well, lake or river. Convertible Jet Pump can be used for
shallow well (25' or less), with the shallow well Jet assembly.
For Professional Technical Support call 1-844-242-2475
1. CASED WELL APPLICATION, 4" OR LARGER CASING (Fig.1)
A hole bored into the earth with machinery. Depths range from a few feet
to 25 feet. Common well diameters are 4", 5", 6" and 8" for domestic water
wells.
2. WELL POINT(DRIVEN POINT) APPLICATION(Fig.2)
Pipe with a pointed screen is driven into the ground below the water table.
The depth is usually less than 25 feet. Available diameters are 1" through
2.
3. APPLICATION FOR SURFACE WATER (Fig.3)
One pipe goes into lake, river, cistern or ponds, suction lift is less than
25'.Install a screen around the inlet pipe to prevent the entrapment of
swimmers, wildlife and debris.
CAUTION: Possible contamination. Do not use surface water for
drinking. The installation shown could be used for sprinkler applications.
Deep Well Application (Double Pipe System)
A hole bored into the earth with machinery. The depth is greater than 25
feet. Common well diameters are 4", 5", 6" and 8" for domestic water
wells.
Deep well systems are identified by two pipe going to the well, one
suction pipe and one drive pipe Convertible Jet Pump can be used for
deep well( over 25' ), with a deep well Jet assembly in the well. The
suction pipe and drive pipe are attached to the Jet assembly.
5