K2 Pumps WPD07502K Manual Del Propietário página 9

4. WELL TO PUMP CONNECTION
Shallow Well Application Only
1. Thread 1-1/4in. PVC MPT×S Male Adapter into
pump. Cement a short horizontal 1-1/4 in.PVC rigid
Pipe into adapter. (Fig .1)
3. Completed installation is shown Fig. 3a.3b.3c.
For Cased well
Deep Well Application Only
1. Remove two bolts, take the shallow well ejectors
included venture and nozzle out, take out gasket seal.
(Fig. 1)
3. Completed installation is shown. (Fig. 3)
Note: slopes all inlet piping slightly upward from well to the pump to prevent trapping air.
For Professional Technical Support call 1-844-242-2475
2. Cement a 1-1/4in. PVC Slip× Slip Union into a short
horizontal 1-1/4 in.PVC rigid Pipe.
piping slightly upward from well to the pump to
prevent trapping air
For Well Point
2. Install 1-1/4in. PVC MPT×S Male Adapter at the top
tapping and 1in. ×3in.Galv.Steel Nipple at the
bottom tapping of pump face. Thread 1in. PVC FPT×S
Female Adapter into the nipple. Cut 1in. pipe and
1-1/4in. pipe. Cement them to the adapter and tee
assembling in the previous step
PIPING IN WELL
Slopes all inlet
.(Fig.2)
For Surface water
INSTALLING
.
(Fig. 2)
9