Cleaning The Pump Unit; Cleaning The Tubing; Assembling The Breast Pump - Medela Swing Maxi Instrucciones De Uso

5.2 Cleaning the pump unit

To prevent electric shock and damage to the material:
10
• Unplug the pump unit before cleaning it.
• Do not immerse the pump unit in water.
• Do not spray or pour liquid directly onto it.
1. Wipe the pump unit with a clean towel moistened with soapy water.
2. Wipe the pump unit dry with a clean, dry towel.

5.3 Cleaning the tubing

If the tubing becomes mouldy, discontinue use and replace tubing.
Do not use the device with wet tubing; doing so will damage it.
Washing
Since the tubing only conveys an air flow (no contact with milk), normally cleaning of the
tubing is not necessary.
i
Inspect the tubing. If you find condensation in the air tube, wash and dry it immediately or
replace it. If you see breast milk inside the tubing do not attempt to wash or sanitise it.
Instead contact the manufacturer.
1. Separate the tubing from the device.
2. Rinse the tubing by pouring cool water into both short tubing ends until it flows out of the
long tubing end.
3. Wash the tubing in warm, soapy water.
4. Rinse the tubing with clear water.
Drying
1. Shake out any water droplets.
2. Hang the tubing to air dry.
3. Make sure that the tubing is completely dry before using it.

6. Assembling the breast pump

Only use clean and dry parts for assembly. Refer to chapter 5 for cleaning.
CAUTION
CAUTION
NOTICE
Information