Remote Control - Sony DAR-X1R Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Display
The clock has stopped.
, Set the clock again (page 116).
, The clock stopped due to a power failure that
lasted for more than 1 hour. Reset the clock
(page 116).
The TIMER REC indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc inside the recorder.
, The inserted DVD is protected (page 52).
The recording mode indication is incorrect.
, When the recording or dubbing is less than ten
minutes, or if a picture with little movement is
displayed for more than ten minutes, the
recording mode indication may be displayed
incorrectly. Note that the actual recording or
dubbing itself was correctly made in the selected
recording mode.
, After playing titles recorded in EP and SLP
mode, the recording mode indication may
change depending on the recorded programme.
The clock does not appear in the front panel
display when the recorder is turned off.
, "Dimmer" in the "Others" setup is set to "Save
Power" (page 126).

Remote control

The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder.
, The remote's manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 24).
, The remote is not pointed at the remote sensor on
the recorder.
GB
134
Others
The recorder does not operate properly.
, Restart the recorder. Press down [/1 on the
recorder for more than ten seconds until
"WELCOME" appears in the front panel display.
, When static electricity, etc., causes the recorder
to operate abnormally, turn off the recorder and
wait until the clock appears in the front panel
display. Then, unplug the recorder and after
leaving it off for a while, plug it in again.
Five numbers or letters are displayed in the
front panel display.
, The self-diagnosis function was activated (see
the table on page 135).
The disc tray does not open after you press Z
(open/close).
, It may take a few seconds for the disc tray to
open after you have recorded or edited a DVD.
This is because the recorder is adding disc data to
the disc.
The disc tray does not open and "LOCKED"
appears in the front panel display.
, The disc tray is locked. Cancel the Child Lock
(page 77).
The disc tray does not open and "TRAY
LOCKED" appears in the front panel display.
, Contact your Sony dealer or local authorized
Sony service facility.
The disc tray does not open and you cannot
remove the disc after you press Z (open/
close).
, Turn off the recorder. Once the clock appears in
the front panel display, disconnect the mains
lead. (If the recorder does not turn off or if the
clock does not appear in the front panel display,
disconnect the mains lead anyway.) Connect the
mains lead again while pressing down Z on the
recorder, and release the button when the disc
tray opens. Then, keep [/1 on the recorder
pressed for about ten seconds until
"WELCOME" appears in the front panel display.

Publicidad

Tabla de contenido
loading

Tabla de contenido