Switching On/Off - MBM G1008/98 Instrucciones Para El Funcionamiento

3. 5.
INSTRUCTIONS FOR USE
When filling the cooking compartment, respect
the maximum level indicated on the inside.
Do not introduce large pieces of kitchen salt into
the cooking compartment as it deposits at the
bottom and does not completely dissolve.
Hot or cold water can be introduced into the cooking
compartment by acting on the 2 knobs (Fig.4).
In order to fill the cooking compartment with water, you must:
•
Lift the lid of the cooking compartment if necessary.
•
Turn the pipe in the direction of the cooking compartment
(Fig. 5).
•
Open the water filling knob at the desired position (hot-
cold-both) (Fig. 4A) and fill the tank as needed.
•
Close the knob/s when filling is complete (Fig.4B).
•
Reposition the pipe so it does not get in the way of the lid
when it closes (Fig. 5).

Switching On/Off

The appliance must be switched on after having
filled the cavity with water. Do not switch it on
when empty (see previous page).
The appliance must be switched on after having
filled the cooking compartment with water. Do not
switch it on when the cooking compartment is empty.
During operation, check the level of the water
inside the cooking compartment and bring it to
the correct level as needed by acting on the water
filling knobs.
Turn the burner control knob while holding it in the piezoelectric
position (Fig.7D).
At the same time you turn the knob, press the button (Fig.6) to
generate the spark which ignites the pilot light.
When the pilot light has been lit (seen through the lower
inspection hole of the appliance) turn the knob (Fig.7E) to
minimum or maximum to adjust the flame.
Turn the switch-on knob to "Zero" (Fig. 7C) to switch the
appliance off.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
A
B
A
C
Fig.7
- 11 - - 11 - 11 11
Fig.4
A
B
Fig.5
Fig.6
D
E