Introduction - Gauss BT010 Manual Del Usuario

1. INTRODUCTION

The BT010 Electronic Auto Parts Tester was
especially designed to test components of the electrical
and electronic systems in motor vehicles.
The following automotive components can be
tested:
• Sensors that provide variable voltage, variable frequency
and pulse signal. Some examples of these sensors are:
TPS, EGR, MAF, CKP, temperature sensors, magnetic
sensors, Hall sensors, fuel level meters, etc.
• Electronic or electromechanical regulators for alternator,
12 or 24 Volts, type A or type B, common or controlled by
the ECU type PD or PWM. BSS and LIN type regulators
controlled by the ECU (Electronic Control Unit) can be tes-
ted to check the stand-alone adjustment voltage
• Electronic ignition modules controlled by a pickup coil or
by the vehicle's ECU
• Electronic or contact breaker points ignition coils. This
allows for testing coils with built-in ignition module, and
coils with two, four or six high-voltage outputs. In addition
to the high-voltage spark gap test, a kilovolt meter is also
available to measure the output voltage from the coil and
reach a more accurate diagnosis of the status of the igni-
tion coil
• Electrical parts that require DC power supply in the 12
or 24 Volt range, such as: common and halogen lamps,
horns, alarms, electric fans, windshield wipers, etc.
• Other electrical parts, such as: alternator rotors, alterna-
tor rectifiers, rectifier diodes, light and horn relays, flasher
relays, starter motor auxiliary relays, oil sensors, etc.
It is NOT possible to test alternators or starter mo-
tors with this equipment, because they are parts that re-
quire a special condition and high operating currents that
cannot be supplied by the Tester's internal power supply.
Fuel pumps can be powered with the Tester, but it must
be taken into account that for proper testing a mechanical
assembly is required that allows for measuring flow, pres-
sure and current.
The Tester works with 110/220 Volts AC power
voltage. The voltage should be selected with the switch
at the back of the equipment, which comes set to 220V by
default.
Electronic Auto Parts Tester Manual BT010
The Tester is delivered with the following wiring
harnesses and testing accessories:
1.1. A set of cables for tests using the power supply (PU01):
1.2. A set of cables for testing ignition coils or sensors
(PU02):
1.3. An accessory for testing regulators controlled by the
vehicle's ECU:
1.4. An auxiliary coil for testing ignition modules and pro-
pulsion coils (BA01):
EN
25