Installing And Connecting The Unit - Handpiece Experts Torque Power BL ISO Manual Del Operador

4 Installing and connecting the unit

4
Installing and connecting the unit
1
4
5
3
A
12
iv e iv e
D r D r
a r k a r k
P r o P r o
e P e P
f o r f o r 6 9 6 9
e r c e r c
3 6 3 6
e d e d
t u r t u r m m m m Y 1 Y 1
f a c f a c C o C o , N , N
n u u r g u r g
n u 2 - A 2 - A
M a M a
8 1 8 1 n s b n s b
d e d e
Ö g Ö g
8
10
6
12
10
7
3
) )
0 V 0 V
(1 2 (1 2
) )
0 V 0 V
M M
- 0 2 - 0 2 (1 2 (1 2
E 2 4 E 2 4
1 M 1 M
4 - 0 4 - 0
T IY T IY
M 2 M 2
T IY T IY
5
c c
s In s In
t e m t e m
S y s S y s
iv e iv e
D r D r
S A S A
, U , U
5a
The Torque Power BL ISO was developed for the pur-
pose of converting the compressed air emitted by a den-
tal treatment center into electrical energy. A straight/con-
tra-angle dental handpiece can be powered by this
energy. The electric motor of the Torque Power BL ISO
replaces the air drive port (for highspeed handpieces or
air-driven motors) previously used on the dental treat-
ment center.
It is connected and controlled solely via the hose cou-
pling (5a) of the air-driven instrument.
Control is effected by means of the pneumatic foot
switch (A) which is available on the unit side. Power
is supplied by an external transformer (11).
Site of installation
Mount the Torque Power BL ISO (1) at an easily acces-
sible location on top of or adjacent to the dentist element
of the treatment center.
Be sure to choose the installation site of the Torque
Power BL ISO so that the Torque Power BL ISO can
easily be connected to the dentist element with the pre-
viously used highspeed handpiece or air motor hose (5).
Ensure that the unit has a safe and stable stand.
Connection
Detach the highspeed handpiece, quick coupling or air
motor used until now from the supply hose and plug con-
nection piece (5a) into the four-hole connection (8) on
the rear side of the unit.
CAUTION
With a 5-hole hose, remove the lamp from the hose prior
to operation.
Fit the electric motor hose (3) to the connection piece (7)
on the rear side of the Torque Power BL ISO. Attach the
corresponding electric motor to the motor hose (see
Operating Instructions of motor). Place the motor in the
holder on the dentist element which was previously
occupied by the air-driven instrument.
Connect the connector of the transformer connecting
cable (6) to the connection piece (10) of the Torque
Power BL ISO.
Plug the power cable (12) into the transformer.
All cables must be safely routed, avoid stumbling
hazards!
Plug the transformer power plug into a grounded socket
outlet.
Do not use any transformer other than the one approved
and supplied by Handpiece Experts, i.e. TIYM24-02M
6
(120 V) or TDYN-01M (120V)!
Distributed by Handpiece Experts Inc.
Operating Instructions Torque Power BL ISO
62 28 527 D 3547
D 3547.201.01.01.02