Handpiece Experts Torque Power BL ISO Manual Del Operador página 19

Distributed by Handpiece Experts Inc.
Operating Instructions Torque Power BL ISO
Bur Speed
Gear Ratio
Motor Speed Gear Ratio
Bur Speed
Gear Ratio
Motor Speed Gear Ratio
Bur Speed
Gear Ratio
Motor Speed Gear Ratio
Bur Speed
Gear Ratio
Motor Speed Gear Ratio
62 28 527 D 3547
D 3547.201.01.01.02
Torque Power BL ISO Torque Power BL ISO
1 2
Motor Speed
3
Endo
22
Torque Power BL ISO Torque Power BL ISO
1 2
Motor Speed
3
Endo
22
Torque Power BL ISO Torque Power BL ISO
1 2
Motor Speed
3
Endo
22
Torque Power BL ISO Torque Power BL ISO
1 2
Motor Speed
3
Endo
22
Recalling stored handpiece settings
The unit has four save keys (22)
Red – Gear ratio, save key 1
Blue – Gear ratio 1:1, save key 2
Green – Reduction ratio, save key 3
Endo contra-angle handpiece – Endo save key (black)
After the respective save key (22) is briefly pressed, the
corresponding stored settings are recalled and shown
on the display.
The following values and settings are stored in the save
keys at the factory:
Save key 1 (red):
Burr speed 200,000 rpm
Motor speed 40,000 rpm
Gear ratio 1:5
Instrument light ON
Save key 2 (blue):
Burr speed 40,000 rpm
Motor speed 40,000 rpm
Gear ratio 1:1
Instrument light ON
Save key 3 (green):
Burr speed 1,000 rpm
Motor speed 6,000 rpm
Gear ratio 6:1
Instrument light ON
Endo save key (black):
Burr speed 347 rpm
Motor speed 40,000 rpm
Gear ratio 115:1
Instrument light OFF
If the foot switch is actuated while the straight/con-
tra-angle handpiece is removed from its holder, the elec-
tric motor starts running. At the same time, the actual
motor speed and burr speed as well as the preselected
gear ratio of the handpiece being used are shown on the
display.
If the pedal is pressed to the floor, the maximum
programmed speed is then displayed and attained.
If the air supply can be variably adjusted with the foot
switch, the speed and the displayed speed value will
also vary between the minimum and the programmed
maximum speed.
5 Operation
15