ClicBot KY002CK10 Manual Del Usuario página 48

Подключение
Соединение через точку доступа подходит для сценариев, где нет сети Wi-Fi или
плохой сигнал Wi-Fi.
Способ подключения через точку доступа:
1. На экране головного модуля Brain смахните пальцем снизу вверх, чтобы войти в
системное меню, затем выберите значок устройства , нажмите «подключение
к точке доступа», чтобы сгенерировать QR-код точки доступа;
2. Откройте приложение ClicBot и выберите . Нажмите «Подключиться к Brain»,
а затем выберите «Горячее подключение», чтобы войти в режим подключения
через сканирование;
3. Используя камеру на мобильном устройстве, просканируйте QR-кода точки
доступа центрального модуля, чтобы установить соединение.
Подключение к горячей точке
Нажатие кнопки для соединения горячей
точки порта Brain. Сканирование QR-кода.
Центральный модуль генерирует QR- Сканирование QR-кода точки доступа
код точки доступа для установления соединения
92
Сведения о безопасности
Any changes or modifications not
expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
GB19865-2005、GB6675.1-2014、GB6675.2-2014、
GB6675.3-2014、GB6675.4-2014
NOTE:This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
This device complies with part 15 of the frequency energy and, if not installed and
FCC Rules. Operation is subject to the used in accordance with the instructions,
condition that this device does not cause may cause harmful interference to radio
harmful interference (1) this device may communications. However, there is no
guarantee that interference will not occur
not cause harmful interference, and (2)
this device must accept any interference in a particular installation
received, including interference that may
cause undesired operation.
Безопасность и конфиденциальность
If this equipment does cause harmful
interference to radio or television
reception,which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
RSS-Gen Issue 4 December 2014"&"CNR-Gen 4e
the interference by one or more of the
Décembre 2014:
following measures:
--English:
--Reorient or relocate the receiving This device complies with Industry Canada licence-
exempt RSS standard(s).
antenna.
Operation is subject to the following two conditions:
--Increase the separation between the
(1) This device may not cause interference, and (2)
equipment and receiver.
This device must accept any interference, including
--Connect the equipment into an outlet on
interference that may cause undesired operation of
a circuit different from that to which the the device.
receiver is connected. --French:
Le présentappareilestconforme aux CNR d'Industrie
--Consult the dealer or an experienced
Canada applicables aux appareils radio exempts
radio/TV technician for help.
de licence. L'exploitationestautorisée aux deux
conditions suivantes:
The device has been evaluated to meet (1) l'appareil ne doit pas produire de brouillage, et
general RF exposure requirement. The (2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le
device can be used in portable exposure
brouillageest susceptible d'encompromettre le
condition without restriction.
fonctionnement.
FCC ID: 2AWR5-KY002
IC ID: 26344-KY002
93