Publicidad
Idiomas disponibles
Idiomas disponibles
CEBORA S.p.A.
4.2
Power Source description (fig. 3).
GB
BO - Socket.
Connect the earth cable connector (workpiece potential).
BP - Connector.
Connector type DB9 (RS232 serial line) to use for updating the Welding System programs (Power
Source, Wire Feeder and Control Panel).
BR - Socket.
Connect the power cable connector of the Power Source - Wire Feeder extension (2).
BS - Connector.
Connect the service cable connector of the Power Source - Wire Feeder extension (2).
BU - ON/OFF switch.
Main switch of the Welding System (Power Source, Wire Feeder, Control Panel and Robot Interface) (not
including the Robot management part).
BV - Power cord.
BY - Connector.
Connect the connector of the cable (1) to connect the Power Source – Control Panel.
BZ - Connector.
Connect the connector of the cable (3) to connect the Power Source – Robot Interface.
5
COOLING UNIT.
The Cooling Unit was designed to cool the torches used for welding.
It must be used exclusively with the Power Sources described in this manual.
5.1
Technical specifications.
U1
1x400V
50/60 Hz
I1max
Pmax
P (1l/min)
5.2
Cooling Unit description (fig. 3).
BX - Slot.
Slot to inspect the coolant fluid level.
BQ - Quick-fitting valves.
Do not use in Robot applications. Connect the cooling circuit hoses to the valves BT.
Do not short-circuit them.
3300305-B
Rated supply voltage.
Single-phase power supply.
Frequency.
Maximum absorbed current.
Maximum pressure.
Refrigerant power measured at 1L/min.
fig. 3
16
18-03-2016
Publicidad
