Reverse drive
DANGER
Risk of injury!
When reversing, there must not be any
risk for third parties, have somebody
marshal the driver if necessary.
Press slowly the accelerator pedal "re-
verse".
Driving method
The accelerator pedal can be used to
vary the driving speed infinitely.
Avoid sudden operation of the pedal as
this may damage the hydraulic system.
In the event of power loss on inclined
surfaces, slightly reduce the pressure
on the accelerator pedal.
Brakes
Release the accelerator pedal, the ma-
chine brakes automatically and stops.
Note: The braking effect can be supported
by pressing the brake pedal.
Driving over obstacles
Driving over fixed obstacles which are 70
mm high or less:
Drive forwards slowly and carefully.
Driving over fixed obstacles which are
more than 70 mm high:
Only drive over these obstacles using a
suitable ramp.
Sweeping mode
CAUTION
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
Note: To achieve an optimum cleaning re-
sult, the driving speed should be adjusted
to take specific situations into account.
Note: During operation, the dust filter
should be shaken off and cleaned at regu-
lar intervals.
Note: When frequently working in areas
with fine dust, the filter must be cleaned
more often.
Control lever
1 Control lever roller brush
2 Control lever waste container
3 Control lever side brush
4 Control lever container flap
Control lever roller brush
Control lever roller brush (1) to the front:
Roller brush is lowered.
Control lever roller brush (1) to the
back: Roller brush rises.
22
Control lever waste container
Control lever waste container (2) to the
front: Waste container is lowered.
Control lever waste container (2) to the
back: Waste container is raised.
Control lever side brush
Control lever side brush (3) to the front:
Side brush is lowered.
Control lever side brush (3) to the back:
Side brush is raised.
Control lever container flap
Control lever container flap (4) to the
front: The container flap of the waste
container opens.
Control lever container flap (4) to the
back: The container flap of the waste
container closes.
Sweeping dry floors
1 Blower lever
ein / aus
Switch on the blower.
With surface cleaning:
Control lever roller brush (1) to the front:
Roller brush is lowered.
Control lever container flap (4) to the
front: Container flap opens.
With cleaning of side edges:
Control lever side brush (3) to the front:
Side brush is lowered.
Sweeping damp or wet floors
Switch off the blower.
With surface cleaning:
Control lever roller brush (1) to the front:
Roller brush is lowered.
Control lever container flap (4) to the
front: Container flap opens.
With cleaning of side edges:
Control lever side brush (3) to the front:
Side brush is lowered.
6
EN
-
Emptying waste container
DANGER
Risk of injury!
During the emptying process, persons
and animals must not stay within the
swivelling range of the waste container.
DANGER
Risk of crushing!
Never reach into the rod assembly for
the drainage mechanism. Do not stay
under the raised container.
DANGER
Danger of tipping!
Place the device on an even surface
during the emptying process.
ATTENTION
Risk of personal injury or damage!
Stones may be catapulted off by the ro-
tating roller brush during the emptying
process.
Raise the roller brush and side brush by
means of the control levers, in order to
do so, pull the control levers (1 and 3) to
the back.
Close the container flap, in order to do
so, move the control lever (4) to the
back:
Raise the container flap, in order to do
so, move the waste container control le-
ver (2) to the back:
Slowly drive towards the collection con-
tainer.
Lock parking brake.
Open the container flap, in order to do
so, push the container flap operating le-
ver (4) to the front and empty the waste
container.
Close the container flap, in order to do
so, push the container flap operating le-
ver (4) to the back until it is tipped in-
wards in the end position.
Release parking brake.
Drive away the collection container
slowly.
Lower the waste container into the end
position, in order to do so, move the
waste container control lever (2) to the
front