Eldom jaar BK5S Manual Del Usuario página 15

Licuadora de vaso
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 31
Caution:
Do not turn on the appliance if there is no liquid (e.g., water, juice, etc.) in the jug (3).
Put the lid (2) on the jug (3) and lock it by turning it to the right; place the stopper (1) in
-
the lid – Fig. 3.
Caution:
In the lid (2), there are openings making it possible to pour out the contents of the
jug without removing the lid – Fig. 4. When the blender is being operating, the lid (2)
should be put on so that the openings are near the handle. Otherwise, the liquid may
escape through the openings in the lid during operation.
-
Put the jug (3) into the socket (5) as indicated and lock it by turning it to the right – Fig. 8.
Caution
The appliance has a safety device preventing it from being turned on without the jug
(3) properly in place.
-
Plug the base (6) into the mains socket compliant with the parameters specified in the
instructions manual.
The appliance starts operation after pressing and holding the power switch (7). The
-
appliance operates as long as the power switch (7) is pressed. The best effect is obtained
with the pulse operation.
-
The maximum continuous operation time is 1 minute.
Caution
Do not turn on the appliance with an empty jug (3) or without the lid (2) on.
Observe the continuous operation time of the appliance. Exceeding the operation
time and lack of sufficient breaks can lead to irreversible motor damage.
If the blade (4) is blocked, turn off the appliance immediately, disconnect it from the
-
mains and leave it to cool for at least 15 minutes. Eliminate the cause of the blockage.
-
Wait until the blade stops before removing the jug (3) from the base (6).
-
Disconnect the power cord plug from the electric socket.
To remove the jug (3) from the base, turn it to the left and lift it up.
-
Remove the lid (2) by turning to the left and reassemble it, this time so that the openings
-
(Fig. 4) are located at the spout of the jug (3).
-
Pour the contents into a glass.
-
Clean all components when finished.
Operation with the container (9):
Place the container (9) on a flat, horizontal surface with the opening facing up and put
-
the products in it and pour in the liquid.
-
Cut the products into small pieces. Do not place ingredients above the maximum level
(600 ml) marked on the container (9).
15

Publicidad

Tabla de contenido
loading

Tabla de contenido