Cub Cadet Commercial 53RIHJUV603 Instrucciones De Funcionamiento Originales página 18

EN
Fitting the steering column
Release the clamping lever in an anti-clockwise
direction .
Tip the steering column forwards into the required
position .
Tighten the clamping lever in a clockwise direc-
tion to lock the steering column in this position.
Folding the driver's seat downwards/
upwards
Folding the driver's seat upwards
Pull the release lever upwards
Push the seat forwards
rod .
Folding the driver's seat downwards
Pull the seat support rod upwards slightly
Lower the seat down until it latches into the
holder .
Note
Ensure that the driver's seat latches in cor- r r
rectly.
Setting the cutter wheels
The cutter wheels should never be lower than
6-12 mm above the ground at the lowest cutter
position. The cutter wheels are not designed to bear
the loads generated by the cutters and may have
to be offset accordingly. They are used solely for
Always move the cutting wheels so they line up
evenly.
Note
The number of cutter deck wheels varies
depending on the model.
Operation
Attention !
Also observe the information in the operating
manual for the engine.
Note
Comply with the national/municipal regula-
tions concerning the times when the appli-
ance may be used (if required, contact your
local authority).
18
.
until the seat support
.
Switching on/off the headlights
(optional; depending on the model)
To turn the headlights on, set the switch to "ON".
To turn the headlights off, set the switch to "OFF".
Opening the fuel tap
You can use the fuel tap to open and close the
supply of fuel to the left and right fuel tanks.
ON
NO
Fuel supply opened
NO
OFF
Fuel supply closed
Note
There is a petrol tap located on each petrol
tank (depending on the design). The petrol
tanks can be used together or even individu-
ally.
If both petrol taps are opened, and one of
the petrol tanks is empty, the engine will not
start. In order to be able to start the engine,
shut the petrol tap if the empty tank or top it
up.
Engaging / disengaging the parking
brake
To engage the parking brake, pull the lever [A]
backwards to the stop until it latches in
To switch the parking brake off, push the lever [B]
forwards and simultaneously press the
lever [A] forwards fully
Note
Starting the motor needs the parking brake
activated due to the safety locking system.
If you press one of the drive pedals with the
parking brake activated, the engine shuts
down automatically through the safety lock-
ing system.
Attention !
Always switch on the parking brake before
leaving the device.
Setting the engine speed
using the throttle.
Fast engine speed =
Slow engine speed =
Operation
I/
.
/
.
769-11758