Tips On Lawn Care; Switching The Device Off; Display Cluster (Depending On The Model; Optional) - Cub Cadet Commercial 53RIHJUV603 Instrucciones De Funcionamiento Originales

Operation
Sit down on the driver's seat.
Put on the seat belt.
Start the engine as indicated.
Set the throttle to .
Switch the cutter deck on and then lower it.
Release the parking brake.
To drive off, press on the accelerator pedal.
Information on mowing
maximum engine speed. When adjusting the
cutting height and travel speed, ensure that
the length, type, and dampness of the grass,
adjust the cutting height and driving speed in
order to be able to collect grass with a grass
catcher without any trouble.
Information on mowing
In the event of blockages, reduce speed and
raise the cutting height.

Tips on lawn care

Mowing
A lawn is made up of various different types of
grass. If you mow your lawn frequently, those types
surface will grow better. If you seldom cut the grass,
you will enhance the development of high-growing
types of grass and other weeds, such as clover,
daisies ...).
The normal height of a lawn is approx. 4–5 cm. Only
1/3 of the total height should be mown; therefore
cut 7–8 cm long grass to normal height. Preferably
do not cut the lawn shorter than 4 cm, otherwise
the turf will be damaged in a dry period. If the grass
has grown particularly high (for example, during a
holiday period), cut it back to its normal height in
stages.
Mulching using the accessories (optional)
With mulching, the grass is cut into small pieces
(approx. 1 cm) during mowing and is left on the
ground. A lot of the nutrients in the cut grass are
Ask your specialist dealer for appropriate mulching
accessories.
Note
not mow scrub, weeds, or overlong grass.
769-11758
Pay attention to the following notes:
Do not mow any wet grass, and never more
than max. 2 cm.
Mow the entire length of grass.
Drive slowly and at maximum engine speed.
Clean the lawn mower deck regularly.

Switching the device off

Stop the device.
Switch the cutter deck off.
Set the throttle to the middle position.
Bring the cutter deck to the top position.
Switch the engine off after 20 seconds.
Switch the parking brake on.
Shut the fuel tap.
Remove the ignition key.
Pushing the device
N
Switch the engine off.
Switch the parking brake off.
Press the gear unlocking lever slightly to the right
and then fully back - .
You can now push the device.
Note
Never tow the device. This can cause seri-
ous damage to the gears.
To go further, press the gear release lever fully
forward until it latches in.
Display cluster
(depending on the model; optional)
Depending on the design, the digital display
cluster shows you:
- Maintenance interval for the next oil change
- Engine speed in RPM (revolutions per minute)
- Operating hours performed
Note
The engine speed or the operating hours
performed are only shown when the engine
is running.
EN
21