EN
Maintenance
WARNING !
Risk of injury or property damage
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
Remove the ignition key and the spark-
plug connectors.
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
Never reach into the rotating cutter
blades.
Only have repair and maintenance work
and the replacement of safety compo-
or a specialist service centre.
Only have the cutter blades replaced
or re-sharpened by a specialist service
centre.
Clean the device and all add-on and ac-
cessory parts after every instance of use.
Cleaning the device
Attention !
Do not use high-pressure cleaners for cleaning
the device.
Switch the parking brake on.
Clean the device with a scrubbing brush, hand
brush or a cloth.
Cleaning the cutter deck
DANGER !
Sharp, moving cutting tools
Risk of injury
Wear protective gloves.
Caution when cleaning the cutters.
Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
Attention !
Fuel may run into the combustion chamber.
Damage to engine
The mower must not be tilted to an angle greater
than 30°.
Bring the cutter deck to the top position.
Clean the cutting chamber with a scrubbing brush,
hand brush or a cloth.
22
Starting the device
Observe the servicing instructions in the engine
manual.
At the end of the season, have the mower in-
spected and serviced by a service centre.
Note
After changing the oil, take the waste oil
to a waste oil collecting point or to a waste
disposal company.
Note
Hand over used batteries to your dealer or to
a waste management company. Remove the
battery before scrapping the mower.
Using jump leads
DANGER !
Risk of explosion / short-circuit
Never bypass a defective or frozen
battery with jump leads.
Ensure that the units and the jump lead
clips do not touch each other and that
the ignitions are switched off.
Attach the red jump lead to the positive terminal
(+) of the discharged battery and to the positive
terminal (+) of the donor battery.
terminal (–) of the donor battery.
Connect the other clip to the frame of the engine
block of the device as far away from the battery as
possible.
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Start the device.
Switch the parking brake on.
Disconnect the jump leads in reverse sequence.
Maintenance
769-11758