Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales página 14

EN
Attaching the seat
Remove the cable ties that secured the seat
during transport.
Fit the seat (dependent on the seat design) on the
seat plate:
a: Seat without adjustment lever:
In the rear area with two screws and in the front
area using two tommy screws with washers.
b: Seat with adjustment lever:
c: Plug the cable connector onto the seat contact
plug
If necessary, attach the cable connector to the
seat contact switch and ensure that the cable is
routed so that it is not damaged or squashed.
Note
nected seat contact switch.
Aligning the upper bow-shaped handle of
the rear frame
The bow-shaped handle is folded down for transport.
Remove the two screws from the rear frame
Fully fold out the bow-shaped handle
Attach the bow-shaped handle to the rear frame
using the previously removed screws - tightening
torque 18-27 Nm .
Aligning the drive control lever
Release the clamping screw on the right-hand
drive lever .
Align the drive control lever
Tighten the clamping screw
control lever in this position.
Repeat these installation steps for the left drive
control lever.
Note
Attaching the trailer coupling (optional)
(depending on the model)
Fix the trailer coupling [1] to the rear panel of the
device using screws [2].
14
a-c
.
.
so that it is vertical.
to lock the drive
Fitting the discharge flap on the cutter
deck
(cutter deck 107cm)
Remove the screws [1] and nuts [2] on the dis-
charge opening of the cutter deck.
using the screws [1] and nuts [2].
Removing the transport lock on the dis-
charge flap
(cutter decks 117 - 152cm)
Remove the safety plate or the cable ties (de-
pending on the version).
Putting the battery into operation
-
caused by battery acid and gases emitted
by battery acid
Battery acid is corrosive. Immediately
clean all parts of the device splashed by
battery acid.
Do not smoke; keep burning and hot
objects away.
Charge batteries in a well ventilated and
dry room only.
There is a risk of a possible short circuit
when working with the battery. Do not
place any tools or metal objects on the
battery.
Risk of poisoning and injury from battery
acid
Wear safety goggles and protective
gloves.
Do not allow battery acid to come into
contact with skin.
If battery acid is sprayed in your face or
water and seek medical attention.
If you have swallowed battery acid, drink
a lot of water and seek medical attention.
Store batteries out of the reach of
children.
Never tilt the battery, as battery acid may
run out.
Bring the remaining, unused battery acid
to your dealer or to a waste disposal
company.
Assembly
[3] to the discharge opening
DANGER!
DANGER!