Starting The Engine; Stopping The Engine - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

Operation
Applying/releasing the parking brake
To apply the parking brake
control levers into the neutral position fully out into
the recess [A].
To release the parking brake, pull both drive
control levers inwards into the neutral posi-
tion [N] .
Attention!
Always switch on the parking brake before
leaving the device.
Setting the engine speed
using the throttle.

Starting the engine

Note
The choke
no choke. The engine is automatically set
to the particular starting process. Follow the
separate instructions in the engine operating
manual.
Open the fuel tap (if present, see engine manual).
Sit down on the driver's seat.
Switch the parking brake on.
Set the throttle to .
If the engine is cold, pull out the choke or set the
.
throttle to
Press the ignition key
Insert the ignition key into the ignition lock.
Turn the ignition key to
starts running.
Release the ignition key.
Set the ignition key to
Note
A start attempt should take a maximum of
5 seconds. Wait 10 seconds before trying
again.
Reset the choke / throttle slowly until the engine is
running smoothly.

Stopping the engine

Set the throttle to the middle position.
Let the engine run for approx. 20 seconds.
Set the ignition key to
Remove the ignition key.
Switch the parking brake on.
, push both drive
:
until the engine
.
.
Driving
WARNING!
Risk posed by abrupt starting, sudden
stopping and driving at an excessively high
speed.
Risk of accidents
Drive slowly and brake slowly.
Do not drive at excessive speed.
Be particularly careful when reversing.
Never change the direction of travel with-
When entering corners, always reduce
your speed and adjust the speed to the
turning radius (the tighter the corner, the
lower the speed).
Never adjust the driver's seat when in
motion.
Never operate the device without the
cutter deck.
This device turns on its own axis. The rear wheels
serve as turning points. A conventional device can
turn in circles, but not around its own axis.
The small vehicle length and the ability to turn
around its own axis give this device excellent
manoeuvrability.
This device features in lieu of a steering wheel two
control levers that serve to steer and power the
vehicle. When the control levers are moved to their
maximum positions the wheels rotate at the speed
set at the throttle.
The control lever positions between neutral and
MAX are proportional to the speed set at the throttle.
To familiarise yourself with how to operate the
device (about 30 minutes) you should start the
device on level ground without onlookers.
Note
lawn you should familiarise yourself with the
familiarise yourself with the controls.
EN
-
17