Switching The Device Off; Display Cluster (Depending On The Model; Optional) - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

EN
Tips on lawn care
Mowing
grass. If you mow more frequently, the grown of
turf. If you seldom cut the grass, you will enhance
the development of high-growing types of grass and
other weeds (e.g. clover, daisies ...).
The normal height of a lawn is approx. 4–5 cm. Only
1/3 of the total height should be mown; therefore
cut 7–8 cm long grass to normal height. Preferably
do not cut the lawn shorter than 4 cm, otherwise the
turf will be damaged in a dry period. If the grass has
grown particularly high (e.g. during a holiday period),
cut it back to its normal height in stages.
Mulching using the accessories (optional)
With mulching, the grass is cut into small pieces
(approx. 1 cm) during mowing and is left on the
ground. A lot of the nutrients in the cut grass are
Ask your specialist dealer for appropriate mulching
accessories.
Note
Pay attention to the following notes:
• Do not mow any wet grass, and never more
than max. 2 cm.
• Mow the entire length of grass.
• Drive slowly and at maximum engine speed.
• Clean the cutter deck regularly.

Switching the device off

Stop the device.
Set the throttle to the middle position.
Bring the cutter deck to the top position.
Switch the parking brake on.
Close the fuel tap (if present, see engine manual).
Remove the ignition key.
Pushing the device
20
Display cluster I (depending on the model; optional)
Pull both gear release levers (left and right be-
tween frame and engine) back and press them
downwards into the recess.
You can now push the device.
Note
ous damage to the gears.
To continue driving, pull both gear release levers
out from the recess and push them forwards.
Display cluster
model; optional)
Note
The indicators only come on when the en-
gine is running of if the ignition key is turned
from the STOP position.
Note
If the ignition switch is outside the STOP
started or not.
Note
indicator.
Dependent on the model, the following indications
appear on the LCD display of the display cluster:
Operating hours/battery voltage indication
When the ignition is switched on, the battery voltage
indicator is displayed for a short period, which
then changes to the operating hours indicator. The
operating hours are displayed in 1/10 hours.
The operating hours are always counted except
for when the ignition key is in the "Stop" position or
when it is removed.
-
(depending on the