Maintenance; Cleaning The Device - Cub Cadet 17CIDGHB603 Instrucciones De Funcionamiento Originales

EN
– –
If you turn the ignition key to the
battery voltage is briefly shown and then the total
operating hours.
Charge the battery as quickly as possible.
Î
It may be necessary to have the charging system
Î
checked by a service centre for possible damage.
– –
Perform air filter maintenance immediately (see
Î
engine operating manual).
This indicator appears every 25 operating hours for
a period of 7 minutes.

Maintenance

WARNING !
Risk of injury or property damage
¾ Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
¾ Remove the ignition key and the spark-
plug connectors.
¾ Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
¾ Never reach into the rotating cutter
blades.
¾ Only have repair and maintenance
work and the replacement of safety
components performed by a qualified
specialist or a specialist service centre.
¾ Only have the cutter blades replaced
or re-sharpened by a specialist service
centre.
¾ Clean the device and all add-on and
accessory parts after every instance of
use.

Cleaning the device

Attention !
¾ Do not use high-pressure cleaners for cleaning
the device.
Park the mower on firm and level ground.
Î
Switch the parking brake on.
Î
Clean the device with a scrubbing brush, hand
Î
brush or a cloth.
22
Battery voltage
position, the
Air filter mainte-
–
Cleaning the cutter deck
Sharp, moving cutting tools
ÂRisk of injury
¾ Wear protective gloves.
¾ Caution when cleaning the cutters.
¾ Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
nance
Fuel may run into the combustion chamber.
ÂDamage to engine
¾ The mower must not be tilted to an angle greater
than 30°.
Bring the cutter deck to the top position.
Î
Clean the cutting chamber with a scrubbing brush,
Î
hand brush or a cloth.
Cutters with cleaning nozzle (optional) T
Cleaning
Park the device on a clean and firm foundation.
Î
Switch the parking brake on.
Î
Use a commercially available quick-release cou-
Î
pling to attach a water hose.
Start the engine.
Î
Lower the cutter deck and switch it on.
Î
Allow the engine and cutter deck to run for a few
Î
minutes.
Switch the engine and cutter deck off.
Î
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Bring the cutter deck to the top position.
Î
Start the engine and switch the cutter deck on.
Î
To dry the cutter deck, allow the engine and cutter
Î
deck to run for a few minutes.
Switch the engine and cutter deck off.
Î
Maintenance
DANGER !
Attention !