Transport; Fixing Problems - Cub Cadet 17CIDGHB603 Instrucciones De Funcionamiento Originales

EN

Transport

Note
The device is not approved for public thor-
oughfares in accordance with national road
legislation (StVO).
Short distances
Switch off the cutter deck before driving the
Î
mower.
Prior to driving, put the cutter deck in the highest
Î
position / into transport position "T".
Drive the machine only short distances to change
Î
its location of use.
Long distances
WARNING !
Danger posed by unstable and unsecured
ramps
ÂRisk of serious injury to people and sever
damage to property
¾ If you are transporting the device on a
trailer or in a lorry, first make sure that
the ramp is stable and secure.
Risk of injury or property damage
¾ In the event of doubt, pay a visit to a service centre.
¾ Shut the device down prior to all checks and all work on the cutter deck.
¾ Protect yourself against injury by doing the following prior to all performing work on the device:
- Switch off the engine
- Remove the ignition key
- Engage the parking brake
- Wait until all rotating parts have come to a standstill
- Wait until the engine has cooled down
- Pull the spark plug connector off the engine so that the engine cannot inadvertently start.
Problem
Starter does not turn.
26

Fixing problems

WARNING !
Possible cause
Safety locking system has actuated.
Battery not connected correctly.
WARNING !
Danger posed by inadequate fastening
ÂTurbulence during transport
¾ If you are transporting the device in a
trailer or lorry, fasten it and secure it
adequately.
Attention !
Environmental hazard due to leaked fuel
¾ Do not transport the device in a tilted state.
Transport the device on a transport vehicle over
Î
long distances.
Manually push the device in neutral into/onto the
Î
transport vehicle. For this purpose, pull both gear
release levers N out of the recess and press them
to the right.
Activate the parking brake and secure the device
Î
against slipping.
Remedy
Sit on the driver's seat. Depress the
brake pedal fully and activate the park-
ing brake.
Switch the PTO off.
Connect red cable to the (+) battery
terminal and the black cable to the (–)
battery terminal.
Transport