Lubricate The Front Casters; Cutting Height Adjustment - Briggs & Stratton SNAPPER PRO S120B2561 Manual Del Operador

25
26

Lubricate the Front Casters

Interval: Annually
1. Remove the 1/4-28 bolt (A, Figure 27) screwed into the
caster and install a 1/4-28 grease fitting.
27
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and reinstall the 1/4-28
bolt.
24
4. Repeat the process for the other side of the machine.

Cutting Height Adjustment

The cutting height adjustment pin (A, Figure 28) controls
the mower's cutting height. The cutting height is adjustable
between 1-1/2" (3,8 cm) and 5" (12,7 cm) in 1/4" (0,64 cm)
increments.
Note: Make sure that the pin is inserted into the holes in both
upper and lower plates of the pin box (B).
28
To set the cutting height at 1-1/2" (3,37 cm):
1. While sitting in the operator's seat, press the deck lift
foot pedal (C) forward until it locks into the 5" (12,7 cm)
position.
2. Remove the cutting height adjustment pin from the hole
that it is installed in.
3. Press the deck lift foot pedal forward and then push the
lock lever (D) towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to
rest against the stationary pin (E) in the 1-1/2" (3,37 cm)
cutting height hole.
5. Place the cutting height adjustment pin in the storage
hole (F).
To set the cutting height in the range of 1-3/4" (4,40 cm)
and 4-3/4" (12,06 cm):
1. While sitting in the operator's seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in the desired
cutting height.
3. Press the deck lift pedal forward and then push the lock
lever towards the right to release the lock.
4. Slowly release the deck lift foot pedal until it comes to rest
against the cutting height adjustment pin.
To set the cutting height at 5" (12,7 cm):
SnapperPro.com