Management Via Control Panel - Cebora TIG Sound AC-DC 2643/T Synergic Manual De Instrucciones

CEBORA S.p.A.
The saved working points may be called up by selecting the "Job number" from Robot Terminal. Three
digital signals, Job 0/DC-AC, Job 1/Pulsed On e Job 2, are available for selection (3 bits, 1 ÷ 7).
If a "Job number" = 0 (zero) is selected from the Robot Terminal, some parameters of the saved working
points may be changed from Control Panel using the key AP and knob Y. On display O are visualized the
values modifiable with knob Y, related to the functions selected with the key AP.
The indication of the selected "Job number" appears on display O for 5 seconds. If the message is steady,
once the 5 seconds have elapsed the Control Panel displays the parameters for the selected job point; if
the message is flashing, this indicates that the selected "Job number" does not correspond to any saved
job point, and display O remains flashing.
7

MANAGEMENT VIA CONTROL PANEL.

Control Panel operations depend on the status of the Robot function in the "Second Functions" menu
(par. 10.2).
With the Robot function disabled (rob OFF) the Control Panel maintains full management of the
Welding System (except for the welding command, Arc-on signal, which must always be provided by the
Robot Terminal).
With the Robot function enabled (rob On), operation of the system switches to the Robot Terminal and
the Control Panel maintains partial operation.
NOTE: This Instruction Manual refers to the Power Sources arts. 351, 352 and 353 in Robot applications.
These Power Sources have the Control Panel integrated.
Only operation with the Robot function active (rob On) is described below.
The status of the Robot function may be verified in the "Second Functions" menu (par. 10.2).
With the Robot function active (rob On), Control Panel operations depend on the selected Operating
Mode (par. 6.1). The commands and signals based on this selection are described below.
3.300.772-B
fig. 7
33
GB
10-03-2016