Replace The Battery - Kohler K-10673 Guía De Mantenimiento

Batteries

Replace the Battery

NOTE: It is not necessary to remove the sensor from the cap to
replace the batteries.
Using a 3/32" hex wrench, remove the two screws from the
bottom of the DC sensor.
Remove the battery cover and pull out the battery holder.
NOTE: The batteries may be considered hazardous waste. Discard
the old batteries in accordance with any applicable codes.
Remove and discard the old batteries. If necessary, use a small
flat-blade screwdriver to pry the batteries from the battery holder.
Align the metal poles on the new battery to contact the metal
electrodes in the battery holder. Take care to properly position
each battery, as shown on the battery holder.
Insert four new 1.5 volt "AA" alkaline batteries into the battery
holder.
NOTICE: Do not overtighten the screws. The plastic threads can be
easily damaged.
Reinstall the battery holder and battery cover. Retighten the
screws on the battery holder.
1108709-5-C
All manuals and user guides at all-guides.com
DC Sensor
Battery Holder
Battery Cover
Screws
8 Kohler Co.