EMAK EF 92S/13H Manual Del Usuario página 49

6.3.15 MAINTAINING THE HYDROSTATIC TRANSMISSION
To ensure reliable operation of the transmission, you must maintain the proper oil level. The transmission
filling ports are accessible after removal of the machine's removal tube (
values are included in the manual of the manufacturer that supplied the machine part.
If there are problems with the transmission, get immediate help from an authorized service
centre to prevent serious damage.
6.3.16 OVERVIEW OF BOLT TORQUE
Mowing mechanism:
Central blade bolt
M12 nuts for the mowing mechanism drive pulleys
Steering:
M8x30 bolt to the steering section
M12 bolt to the steering section
Engine:
Bolt to the electromagnetic connector
Bracket screw for the drive belt tension pulley
Self-locking nuts must be replaced with new ones during removal and reinstallation.
6.4 LUBRICATION
Lubricate the machine according to the following schedule.
The bearings of the tensioning pulleys, guide pulleys and mowing mechanism are self-lubricating.
Before storing the machine for an extended time, thoroughly lubricate all areas shown in the schedule.
But particularly the half-axles of the front and rear axles (it is necessary to disassemble the rear
wheels).
Symbol
6.4
Apply grease to:
angle joints of the drive connecting rods - remove and lubricate

brake rod bolt - lubricate the rod near the bolt hole

bolt to the mowing mechanism lift rod - lubricate the rod in the area of the bolt hole

angle joints of the steering connecting rods - remove and lubricate

angle joints of the wheel pins - remove and lubricate

Explanation
Grease
SAE 30 oil
Interval in
hours
49
6.3.9). The prescribed
Torque
30 ± 3 Nm
45 - 55 Nm
15 - 25 Nm
45 - 55 Nm
60 - 70 Nm
25 - 35 Nm