Operation And Programming; Assemble And Charge; Automatic Charging - ECOVACS DEEBOT D8 Serie Manual De Instrucciones

3. Operating and Programming

3.1 Assemble and Charge

Charging Dock Placement
Charge the Robot
Turn the switch on the bottom of the robot to the ON position.
Place the robot on the Charging Dock making sure the Charging Dock electrode and the Charging Pin on the
robot make a connection.
Charge the robot at least 12 hours before the first 3 uses.
Three Ways to Charge

Automatic Charging

The robot can perceive a low
battery when it is working, and
will automatically switch to
Back to Charger Mode when
necessary.
The START/PAUSE key
Charging normally takes about 3 hours.
After charging finishes, the START/PAUSE key
Notice
After the robot's battery is fully charged, DEEBOT's battery management system will reduce to a trickle charge
to save electricity.
To confirm the robot is charging when it is on the Charging Dock, please make sure the START/PAUSE key
blinking or stays illuminated.
All manuals and user guides at all-guides.com
Assemble the Charging Dock and place it on a level floor surface with the base
perpendicular to the ground. Keep the immediate area in front of the charger
(approximately 5 feet) clear of objects and reflective surfaces that would interfere
with the infrared receiver. Plug the Charging Dock in.
Command Charging
You can command the robot
to switch to Back to Charger
Mode at any time with the
Remote Control or the button
on the robot's control panel.
on the robot blinks when the robot is charging.
on the robot stays illuminated.
EN
Manual Charging
Turn ON the power switch on the
bottom of the robot and place it
on the Charging Dock by hand.
Ensure that the Charging Dock
Electrode and the Charging Pin
on the robot make a connection.
is
8