Next Level Racing Elite Serie Manual De Instrucciones página 10

support@nextlevelracing.com
03 Align the holes on the Overhead Uprights with T-Nuts previously installed in STEP 01. Bolt through and
secure with M8 Bolts and Washers. Repeat on the other side.
04 Align the holes on the Overhead Angle Brackets with the T-Nuts previously installed in STEP 02. Bolt
through and secure with M8 Bolts and Washers.
( )
MOUNTING HOLE
05
Install 1 x T-Nut into the front and outside channel of the Overhead Angle Arm.
Repeat on the other side.
PARTS:
• • 4 x M8 40mm BOLTS
• • 4 x M8 WASHERS
PARTS:
Repeat
• • 2 x OVERHEAD ANGLE BRACKETS
on Other
Side
• • 4 x M8 16mm BOLTS
• • 4 x M8 WASHERS
PARTS:
OUTSIDE FRONT
• • 2 x OVERHEAD ANGLE ARMS
• • 2 x T-NUTS
18
06a
Align the through hole on the Overhead Angle Arm with the hole on the Overhead Angle Bracket. Bolt through
and secure with an M8 Bolt, Washer and Flange Nut. Repeat for the other Overhead Angle Arm.
06b
Align the T-Nuts previously installed into the Overhead Angle Arms in STEP 05 with the curved slot on the Overhead Angle
Bracket. Bolt through and secure with an M8 Bolt and Washer. Repeat for the other Overhead Angle Arm.
07
Align the through holes on the Overhead Cross Bar with the T-Nuts previously installed in STEP 05.
Bolt through and secure with M8 Bolts and Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x OVERHEAD ANGLE ARMS
• • 2 x M8 60mm BOLTS
• • 2 x M8 WASHERS
• • 2 x M8 FLANGE NUTS
PARTS:
• • 2 x M8 16mm BOLTS
• • 2 x M8 WASHERS
PARTS:
• • 1 x MAIN CROSS BAR
• • 2 x M8 40mm BOLTS
Repeat
• • 2 x M8 WASHERS
on Other
Side
19