E N G L I S H
A. BATTERY REMOVAL
To remove the batteries for transporting or servicing:
1. Remove Batteries
a. Disconnect the joystick power cable in the rear of the chair (Fig. 1).
b. Carefully remove seat (see Section K. Seat Removal).
c. Remove the shroud by first removing the four wing nuts then lifting up on the shroud.
(Fig. 2).
d. Unwrap the battery strap; unplug and remove batteries from the chair.
e. Lift batteries using battery handles (Fig. 3).
2. Battery Installation
See Section X. Batteries, D for installatio.
Batteries may weigh up to 45 lbs. Care must be taken to avoid injury when lift-
ing up on battery straps.
B. FOOTPLATE ADJUSTMENT
The single footplate can be adjusted in three different ways: height, length, and angle.
1. Height Adjustment (Figure 4)
(4 possible adjustments):
a. Remove the two securing bolts (A).
b. Move footplate to desired height and slide it into slot.
c. Re-install bolts (A) through desired holes.
2. Length Adjustment (Figure 5)
(4 possible adjustments):
a. Remove pin (B).
b. Move footplate to desired length.
c. Re-install pin (B) through desired hole.
3. Angle Adjustment (Figure 6)
Adjust bolt (C) until desired angle is reached.
101244 Rev. G
All manuals and user guides at all-guides.com
(Figures 1, 2, 3)
WARNING
(CB & BB only)
14
1
2
3
4
A
5
B
6
C
V I I I .