Reception Indicator; Manual Synchronisation (Calling The Transmitter) - Junghans Mega 1000 Instrucciones De Uso

Your Mega 1000 provides you with the option of setting the alarm as a daily
repeating alarm (24h alarm) or as a single alarm.
Proceed as follows to set the type of alarm:
Make sure that your Mega 1000 is in ALARM mode. If
this is shown in the display, press button T1 (set+)
T4 T1
and T2 (set-) at the same time to start adjusting the
alarm mode. Now press the T1 (set+) or T2 (set-) but-
ton, to select the desired alarm mode. The selected
T5
alarm mode is displayed in the upper section of the
display, SET AL 24 for the daily repeating alarm and
T3 T2
SET AL – for the one-off single alarm.
After you have selected the desired alarm mode, press the T4 button to return
to setting the alarm time.
The alarm can be switched off by pressing any button.
Preferably the T5 button should be used for this in order to avoid accidentally
altering the settings.
After the alarm has sounded it is no longer active and the "ON" tag disappears.
If you want the alarm to sound again, set the desired time as described above
and reactivate the alarm.
54
All manuals and user guides at all-guides.com

6. Reception indicator

The reception indicator shows whether the watch has been synchronised with
the signals from the transmitter stations.
Make sure that one of the five time display modes is shown in the display and
if this is not the case, press T3 until one of the time display modes is shown.
Press T4 until the reception indicator is shown (time display mode 5: time,
transmitter indicator and reception indicator).
If the reception indicator reads 0 then the watch was properly synchronised
during the previous night. The numbers 1-9 show the number of days in which
watch has not been automatically synchronised due to poor reception. The
indicator returns to 0 the next time the signal is successfully received.

7. Manual Synchronisation (Calling the transmitter)

> 3 sec.
T4 T1
In the various time display modes, it is possible to
carry out a manual synchronisation or so called
transmitter call.
T5
For this purpose press the T1 button for a period lon-
ger than 3 seconds. The display switches itself off
T3 T2
automatically when the synchronisation commen-
ces. The display will remain switched off for the
whole of the synchronisation period (maximum
14 minutes) or until the procedure is manually
discontinued.
55