8 POSSIBLE ANOMALIES AND ALARMS
Anomaly
The oven does not switch on, the
display is off
The cooking chamber does not
heat up properly
Alarm
999
9 INFORMATION FOR DEMOLITION AND DISPOSAL
Pursuant to Art. 13 of Legislative Decree no. 151 of 25 July, 2005, "Implementation of Directives 2002/95/EC,
2002/96/EC, and 2003/108/EC, concerning the reduction of the use of hazardous substances in electrical and
electronic equipment, as well as the disposal some waste".
The crossed bin symbol on the appliance or on its packaging indicates that, at the end of its useful life, the product must be
collected separately from other waste.
The collection of the equipment at the end of its life is organized and managed by the manufacturer. The user who wishes to
dispose of the equipment must therefore contact the manufacturer and follow the procedure defined to allow separate collection
of the equipment at the end of its life.
Appropriate separate collection to recycle, process and dispose of the disassembled equipment helps avoid possible negative
effects on the environment and health, and promotes the re-use and/or recycling of the equipment materials. The unlawful
disposal of the product results in the application of administrative sanctions provided for by the applicable law.
Enrolled on the National Register of EEE Manufacturers, under entry no:
Possible cause
Lack of electricity
Possible activation of the safety
thermostat
Top and/or bottom have been set too
low
Resistors are partially functional
One or more relays are faulty
Failure
Probe broken or disconnected
IT08020000000645
Possible solution
Check socket, plug and power cable, and
internal terminal board in the control
compartment
Open the electrical system compartment
panel and reset the safety thermostat
Increase the percentage of top and/or
bottom
Check voltage on resistors
Check if resistors are faulty
Replace one or more relays
Solution
Connect or replace probe
89