Establishing The Connections; Connecting The Unit To The Flow-Through Filter; Inserting The Uvc Lamp - Oase Vitronic 11 W Puesta En Marcha

Establishing the connections

 E
• Use hoses that are suitable for a pressure of at least 1 bar.
• Shorten the stepped hose adapters according to the hose diameter in use.
• Secure the hose with a hose clip.
• Hand-tighten the union nut of the stepped hose adapter.
• Screw the stepped hose adapter with the flat seal or O-ring onto the connection so that the
connection is leak-tight.
• You can choose from the two connections arranged opposite each other to ensure that the
hose is routed optimally.
– Use the closing cap to close the connection that is not in use.
– Vitronic 55 W: The closing cap has an inspection glass for function checks.

Connecting the unit to the flow-through filter.

Vitronic 18 W, 24 W, 36 W
The unit is suitable for connection to flow-through filters. Both outlet sockets are screwed to
the inlet nozzles on the flow-through filter. Adhere to the instructions for use of the flow-
through filter.
How to proceed:
 F
1. Unscrew the closing cap.
2. Guide the two outlet sockets with the flat seal through the two holes in the container wall of
the flow-through filter.
3. Screw the inlet nozzle with the O-ring onto the outlet socket and hand-tighten the inlet noz-
zle.
4. Connect the supply hose to the inlet socket. (→ Establishing the connections)

Inserting the UVC lamp

CAUTION
The quartz glass and UVC lamp could break and cause cuts.
 Act with caution when performing work on the UVC clarifier in order to avoid cuts.
 Avoid shocks, impacts and abrupt movements to prevent the glass from breaking.
 G
• Loosen the self-tapping screw until the the screw tip is sunk into the casing of the clamping
screw.
• Carefully remove the quartz glass by pulling it forward with a slight turning movement.
• Carefully push the quartz glass with the O-ring as far as the stop in the unit head during in-
stallation.
– Ensure that the O ring is located in the gap between the unit head and the quartz glass.
• Tighten the clamping screw up to the stop.
• Wipe the quartz glass with a damp cloth to remove dirt and fingerprints.
18