Specifications; Installation - Everbilt EBAU25-PCP Manual Del Usuario

Pre-installation (continued)

SPECIFICATIONS

Power Supply Required
Liquid Temp. Range
Individual branch circuit required
Discharge Connection
Discharge Hose Needed
Power Cord

Installation

Attaching the pool cover
1a
base to the pump
□ The pump (A) will only fit into the pool cover base (B)
one way.
□ Tip the pump into the base so that the hose thread is
angled downward.
□ Slide the two locking tabs (shown below) into the
openings on the base.
□ Once inserted, push down on the pump to lock it in.
NOTE: Periodically remove this base to clear any
debris that may collect in the base. A clear path for
the water will allow the pump to perform its best.
Also, the pump can be used without this base for
any other pumping needs.
115V, 60 HZ
32°F to 95°F (0°-35°C)
15 Amp Minimum
3/4 in. garden hose connection
3/4 in. garden hose
SJTW, 18AWG/3C, 25 ft.
A
1
B
Attaching the pool cover
1b
base screws (Optional)
□ For extra security, turn the pump over (A), and
using the three included Philip head screws
(C), attach the pool cover base (B) to the
pump.
C
5
Please contact 1-844-251-7446 for further assistance.
B
HOMEDEPOT.COM