Washing The Mower Deck - Snapper RPX200 Manual Del Operario

Servicing Air Filter
WARNING
Fuel and its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or death.
• Never start or run the engine with the air cleaner
assembly or air filter removed.
NOTICE: Do not use pressurized air or solvents to clean
the filter. Pressurized air can damage the filter and solvents
will dissolve the filter.
1. Remove the fasteners (A, Figure 14) and the air filter
cover (B).
2. To remove the filter (C), lift the end of the filter and
then pull the filter off the intake (D).
3. To loosen debris, gently tap the filter on a hard surface.
If the filter is excessively dirty, replace with a new
filter.
4. Wash the pre-cleaner in liquid detergent and water.
Then allow it to thoroughly air dry. Do not oil the pre-
cleaner.
5. Assemble the dry pre-cleaner to the filter.
6. Install the filter on the intake. Push the end of the filter
into the base as shown. Make sure filter fits securely in
the base.
7. Install air filter cover and secure with fasteners.
22
All manuals and user guides at all-guides.com

Washing the Mower Deck

NOTE: The washout port allows you to connect a typical
garden hose to the left-hand side of the mower deck to
remove grass and debris from the underside.
WARNING
Before running the mower, make sure the hose is
properly connected and does not come into contact with
the blades. When the mower is running and the blades
are engaged, the person cleaning the mower deck must
be in the operator position, and there are no bystanders.
Failure to follow these precautions may result in serious
injury or death.
1. Place the tractor on a level surface.
2. Attach the quick disconnect (not included) (A, Figure
15) to garden hose (B) and connect to washout port
(C) on on either side of mower deck.
3. Run water to remove grass and debris from underside
of mower deck.
4. Turn the mower on and place in the highest cutting
position.
5. Stop the engine (see Stopping the Tractor and Engine).
6. Remove the garden hose and quick disconnect from
the washout port when completed.
7. Repeat for washout port on other side.