Briggs & Stratton 1696617-03 Manual Del Operario página 10

control lever to use other controls. If your model is equipped
with this feature, it will have a decal (Figure 12) on the dash
panel.
12
1. Push down and hold the auger control lever (A,
Figure 13).
2. Push down and hold the traction control lever (F).
3. Release the auger control lever so that the left hand
can reach other controls. If the auger stops, see an
Authorized Service Dealer.
10
13
Cleaning a Clogged Discharge Chute
DANGER
The rotating impeller in the discharge chute throws snow.
Fingers can quickly become caught in the impeller and
result in traumatic amputation or severe laceration. DO NOT
use your hands to clean a clogged discharge chute! Always
use a clean-out tool.
1. STOP the engine. Remove the ignition key or push/pull
key.
2. Make sure that the impeller does not rotate.
3. Use a clean-out tool (G, Figure 14) to remove snow from
the discharge chute. DO NOT use your hands to clean a
clogged discharge chute!
14
Headlight
Some models are equipped with a headlight that illuminates
the area in front of the snowthrower. When you START the
engine, the headlight turns ON. There is no switch.