GET 2ND INJ. KIT Guia De Instalacion página 5

Ocultar thumbs Ver también para 2ND INJ. KIT:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 14
3.
Pull GET second
injector harness out from
the manifold, passing
it through the Ø 11 mm
/ 0.43" hole previously
milled
on
the
airbox
(see C. PREPARATORY
STEPS / "Airbox", Step
7). The harness must
stick out from the airbox
about 310 mm / 12.20".
Pay attention to the
rubber grommet, pre-
assembled
on
GET
second injector harness:
it must be properly fitted
inside the hole milled
on the airbox surface to
avoid air leakage.
4.
Lubricate the rubber
grommet
previously
installed on the airbox
(see C. PREPARATORY
STEPS / "Airbox", Step 6)
with silicone spray and
pass GET fuel hose from
the inside to the outside
of the airbox through
the rubber grommet.
GET fuel hose must
stick out from the airbox
about 280 mm / 11.02".
EN
Outside
Inside
GET
Outside
fuel hose
Inside
8
5.
Place the second
injector support inner
bracket inside the airbox
by aligning it to the 4
holes previously milled.
Place the second injector
support outer bracket
outside the airbox by
aligning it to the 4 holes.
Starting from the outside
of the airbox, insert
the 4 screws included
in the kit into the holes
and internally fix the
brackets with the nuts
provided.
6.
Plug
the
male
connector of the second
injector harness into the
second injector.
9
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido