Getting Started; Product Information - Vornado EVAP3-EU Manual De Instrucciones

Getting Started

A Humidifier is quite useful in supplying necessary moisture to dry air.
It should be used with proper care to prevent over-humidification. A
good rule of thumb would be to gauge the condensation or frost on
windows. Adjust your Humidifier to a point where this condition is at a
minimum. These adjustments should be made when major changes in
outdoor temperatures occur. Humidifiers can be placed in any living
area that has a location that is convenient and provides distribution of
the moist air to the living area.
The measured output of a Humidifier is based upon continuous
operation at standard rating conditions. With normal variations of
indoor and outdoor conditions, the Humidistat controlled Humidifier
will not run continuously, at maximum output, unless the controls are
set to do so.
Initial Humidity requirements:
When initially installed or when placed in operation at the beginning
of each season, the Humidifier equipped with a Humidistat may run
constantly for a day or so and thus evaporate large quantities of
moisture. When the home and its furnishings have absorbed moisture
and become stabilized at the desired humidity level, the amount of
water used will diminish and the Humidifier operation will maintain
the desired humidity level.
8 English
All manuals and user guides at all-guides.com
Before Operating
DO NOT lift the Humidifier out of the carton by the recessed
handle on the Water Tank. This will cause the Water Tank to
detach from the unit and might cause the Humidifier to drop and
become damaged. Reach under the Humidifier, and lift from the
bottom of unit.
Your new Humidifier uses a sizable volume of water, so we
recommend checking the Base and Water Tank for leaks that may
have occurred due to damage caused in shipping.
Note: A visual inspection may not reveal hairline fractures.
To Check For Leaks:
1. Place Humidifier on a water-resistant surface.
2. Remove the Water Tank and fill with water to inspect for leaks.
3. Next, pour several cups of water into the Base to inspect for
leaks.
Not Leaking?
Empty water from Base and install the full Water Tank.
Leaking?
In the slight chance your Humidifier has leaks, please contact the
approved Importer for replacement directions.
Vornado Evap3 Humidifier Parts
®
While your Vornado® Evaporative Humidifier requires
no assembly, you will need to know how to remove the
Water Tank and Filter for cleaning, maintenance, and
filter replacement. The components are as follows:
Control Panel
Easily adjust Fan Settings and set Humidity level:
35% - 60% or Continuous.
Power Head
Powerful motor circulates moist air throughout
the whole room.
2 Vornado Evaporative Filters
Wick up water.
Inlet Grills
Designed for efficient air intake.
Base
Durable, leak-resistant construction.

Product Information

Air Outlet Grill
Initiates Vornado's signature Vortex circulation.
Humidistat
Reads humidity in the room for automatic
humidity control.
Water Tank
Large 5.7 liter capacity
allows for fewer refills.
Gasket
Creates a waterproof
seal between Cap
and Water Tank.
Cap
Easy-to-remove Cap
for convenient Water
Tank refilling.
Fill Port
Releases water from Water Tank into Base.
English 9