Controls; How To Use - Vornado EVAP3-EU Manual De Instrucciones

Controls

C
B
Power Button - turns the unit On or Off. LED indicator lights
A
will illuminate default settings when powered On. Unit will
default to High Fan Speed, Continuous Humidity.
B Fan Setting Button - select desired Fan Setting. Select - Low,
High or Auto.
Low - operation for quiet, nighttime use or smaller rooms.
On Low operation, your Humidifier may run without refilling for
extended periods.
High - operation for fast humidification for larger rooms. High
speed operation will evaporate 9.8 liters of water (+/- 10%) in 24
hours of continuous operation. (This assumes room conditions of
21º C and 30% relative humidity.)
Auto - operation for more precise humidity control. Fan speed
will fluctuate between High, Low and Off to better maintain set
10 English
All manuals and user guides at all-guides.com
A
humidity level with the minimal amount of Fan noise.
Humidity Button - sets desired humidity level. Press Humidity
C
Button until desired humidification level is illuminated, 35% - 60%
or Continuous. The unit will operate until the desired Humidity
level is reached, at this point, the Fan will turn Off and the Fan
speed indicator light will turn Off. The Humidity level indicator
light will remain On. If the Fan does not turn on, the set Humidity
level may be lower than the room humidity level. Increase the
Humidity set point until the Fan turns On. This is an indication
of the level of humidity already in the room. If moisture forms on
walls or windows, lower humidity settings or turn Off Humidifier.
Installing Water Tank
This Humidifier has a 5.7 liter capacity and 9.8 liter output in 24 hours
(if set to High Fan Speed, Continuous Humidity setting).
1. Unplug Humidifier. Place on firm and level surface, such as the
floor.
Note: Spills can occur during cleaning, moving, or refilling Water
Tank, so be careful to avoid spills when doing these activities.
2. Remove the Water Tank by grasping the recessed handle and
pulling towards you (A).
3. Turn Water Tank upside down and Remove Cap (B).
A B
4. Empty any remaining water inside Water Tank. Rinse, wipe clean
and dry with clean cloth or paper towel.

How To Use

5. Place Water Tank in sink with opening at the top and fill Water Tank
with cool tap water.
6. Ensure Gasket, the rubber ring around the Cap, is properly
positioned and replace Cap. Some downward pressure may be
needed to compress the Gasket prior to rotating the Cap 1/4 turn
clockwise.
7. Lower Water Tank into Base, positioning Fill Port (C) over raised
bump in Base (D). Once in nested position, the water outlet valve
inside Cap will open, releasing water into Base.
C
D
English 11