Replace The Bump Knob; Remove The Trimmer Head; Assemble The Trimmer Head; Remove The Brush-Cutter Blade - Cramer 2101786 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
3. Remove the remaining spool.
4. Replace with a new spool.
5. Put the spool in the spool housing.
6. Push the tabs and install the spool cover onto the spool
housing.
7. Push the spool cover until it clicks into position.
5.5

REPLACE THE BUMP KNOB

Figure 16.
1. Simultaneously press the tabs on the sides of the trimmer
head.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob and pry it out with a metal rod (not
provided).
5. Put the new bump knob into the spool housing.
5.6

REMOVE THE TRIMMER HEAD

Figure 18.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
5.7

ASSEMBLE THE TRIMMER HEAD

Figure 18.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
IMPORTANT
You must install the cut-off blade when you use the trimmer
head.
5.8
REMOVE THE BRUSH-CUTTER
BLADE
Figure 19.
WARNING
Apply the guard to the blade.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Loosen the nut clockwise and remove the outer cup.
English

3. Remove the brush-cutter blade.

5.9
ASSEMBLE THE BRUSH CUTTER
BLADE
Figure 19.
Wear gloves and be careful with sharp edges.
Apply the guard to the blade.
Use the specified Nylon locknut which is packed with the
blade, to assemble the blade.
You must change the locknut after you use it for 20 times.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Put the brush-cutter blade on top of the inner cup. Make
sure the blade is in the center.
3. Put the outer cup above the plate.
4. Put the locknut above the outer cup.
5. Tighten the lock-nut counter-clockwise to 44-58" N.M of
torque with a 19mm wrench.
6
TRANSPORTATION AND
STORAGE
6.1

MOVE THE MACHINE

When you move the machine, you must:
Wear gloves.
Stop the machine.
Remove the battery pack and charge it.
Assemble the blade guard.
6.2

STORE THE MACHINE

Remove the battery pack from the machine.
Make sure that children cannot come near the machine.
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
7
WARNING
WARNING
WARNING
WARNING
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

48tx10

Tabla de contenido