Publicidad
Idiomas disponibles
Idiomas disponibles
58
Side Stand
(Refer to the Safety Precautions on page 43.
Check both the side stand spring (1) for damage and
loss of tension, and the side stand assembly for
freedom of movement.
If the side stand is squeaky or stiff, clean the pivot
area and lubricate the pivot bolt with clean engine oil.
Left side
(1)
Right side
)
(1) Side stand spring
(1)
Wheel Removal
(Refer to the Safety Precautions on page 43.
Front Wheel Removal
1. Raise the front wheel off the ground by placing a
support block under the engine.
2. Remove the speedometer cable set screw (1) and
disconnect the speedometer cable (2).
3. Remove the front axle holder nuts (3) and the front
axle holder (4).
4. Unscrew the axle (5). Remove the wheel.
Do not depress the brake lever when the wheel is off
the motorcycle. The caliper piston will be forced out of
the cylinder with subsequent loss of brake fluid. If this
occurs, servicing of the brake system will be
necessary. See your Honda dealer for this service.
(2)
(3)
(5)
(4)
(3)
Owner´s Manual
)
(1) Screw
(2) Speedometer cable
(1)
(3) Axle holder nuts
(4) Axle holder
(5) Axle
Publicidad
