Publicidad
Idiomas disponibles
Idiomas disponibles
60
3. Loosen the drive chain lock nuts (4) and adjusting
nuts (5).
4. Remove the axle nut (6) while holding the rear axle
at the other end with a wrench.
5. Pull out the rear axle (7).
6. Remove the drive chain from the drive sprocket by
pushing the rear wheel forward.
7. Remove the rear wheel.
(7)
(5)
(4)
(4) Lock nut
(5) Adjusting nut
(7) Rear axle
Installation notes
• Reverse the removal procedure.
• Make sure that the slot (8) on the brake panel is
located in the lug (9) in the swingarm (10).
• Tighten and torque the following nuts and bolts:
Axle nut torque:
88 N·m (9.0 kgf·m, 65 lbf·ft)
• Adjust the brake (page 21) and drive chain (page 55).
• Apply the brake several times and check for free
wheel rotation after the brake pedal is released.
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
(8)
Owner´s Manual
(8) Slot
(9) Lug
(9)
(10) Swingarm
(10)
Publicidad
