Descargar Imprimir esta página

End Of Operation - diversey TASKI swingo 2500 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

Replenishing cleaning solvent
Caution:
The flooring may be damaged when working with-
out cleaning solution.
Caution:
The pump must never run dry for an extended peri-
od.
Notice:
A rattling noise from the pump indicates an empty
fresh water tank (Flextank).
• The fresh water tank display lights
up.
Fresh water tank is empty.
• The machine must be switched off.
• Open the tank lid.
• Fill water into the fresh water tank (Flextank), see page 9.
• Add the cleaning product using the dosing cup.
• Tilt the tank cover back to the original position.
Draining dirty water
Recovery tank full display:
• If the Recovery tank display lights up,
the cleaning program is interrupted,
the suction nozzle is lifted and the
suction unit is switched off.
• Drain the recovery tank, see page 12.
Notice:
In case of frothing in the tank, the recovery tank dis-
play also lights up.

End of operation

Manual process
• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• Press the Brush drive ON/OFF but-
ton.
The brush unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the suction unit ON/OFF but-
ton.
The suction nozzle is lifted automati-
cally.
The suction motor is still on for 10
seconds.
12
Automatic process
• Press the Program ON/OFF button.
The cleaning solution supply is
stopped.
• The brush unit is stopped and lifted.
• After 30 seconds, the suction nozzle / squeegee is lifted.
• The suction motor is still on for 15 seconds until it is auto-
matically switched off.
Removing and cleaning the suction nozzle
• Remove the key and actuate the stopping brake.
• Remove both suction hoses from the suction nozzles.
• Compress the position locks. The
squeegee is released and can be re-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
• Assemble the suction nozzle to the nozzle/hose holder.
Notice:
Only cleaned and intact blades ensure optimal suc-
tion results!
Draining and cleaning the recovery and fresh
water tank (Flextank)
Notice:
Drain water or cleaning solution must be disposed
of in compliance with the national regulations.
Notice:
When draining the recovery tank, the regulations of
the detergent supplier regarding personal protec-
tive equipment of the cleaning solution manufactur-
er must be observed.
• Remove the key and actuate the stopping brake.
Proceed as follows:
• Remove the drain water hose from
the holder.
• Hold the hose level with the edge of
the tank, with its opening facing up-
wards. Open the red cover, slowly
lower the hose end to the drain and
empty the recovery tank.
• Lift the fresh water tank (Flextank), put it into the recovery
tank at the lowest point and discharge it.
• Remove the empty fresh water tank (Flextank) from the re-
covery tank and thoroughly rinse it with clean water.
• Thoroughly rinse the recovery tank with clean water.
• Remove the solids filter (yellow) and
thoroughly drain and rinse it under
running water.

Publicidad

loading