Making Hot Water - Ascaso Dream PID Manual Del Usuario

ascaso
Possible problems.
The cream may be too thin and lack
consistency.
1. One possible reason is that the
milk has already been heated.
2. The milk has been overheated (the
steam nozzle has been placed
too deeply in the jug and the milk
has been heated without allowing
the air to circulate on the surface)
before the required texture has
been attained. Step 1 (texturing)
has not been performed
properly and the air has not
been allowed to work the milk.
5.

Making hot water

3. Put a cup below the steam nozzle
.
5
4. Turn on the hot water/steam knob
and press button (3-I) (the pilot
4
light will come on
the reverse operation to obtain the
required water.
6.
Functions of the PID
model
The PID models have a control
system consisting of a screen
two control buttons
the following functions:
1. Coffee temperature, shown on
the screen. To change it, press
button , the screen will display
22
the message PrG, indicating that
it is in temperature programming
mode. Press button
the temperature, press
increase it. If three seconds pass
without a button being pressed, the
system will return to its initial state.
2. Temperature units, in °C or F.
3. Pre-infusion, selecting the pump
activation and stop time between
0 and 5 seconds.
4. Timer, showing the time taken
to make a coffee. This function
can be turned on or off in the
32
MAN.29 V8 - MANUAL DREAM PID-ONE 2022.indd 32 MAN.29 V8 - MANUAL DREAM PID-ONE 2022.indd 32
5. In stand-by mode, selecting an
6. Correction parameter between
Enter the programming menu to
change the values of parameters 2 to
7. The process is as follows:
7. With the machine on, press and
. Carry out
23
8. Press button
9. To change the value of the
21 and
to control
22 23
10. After three seconds without
22 to reduce
to
23
in the following way: With the machine
on, press the button
seconds. The screen
text PrS, indicating that the factory
settings have been reset.
programming menu. If on,
the screen shows the time
21
taken to make a coffee, not the
temperature.
activation period from 0 (off),
0.5/1/2 hours.
water temperature and
measurement in the machine. This
enables the water temperature to
be adjusted according to room
temperature.
hold button while pressing
23
for three seconds. The screen
will show the words SET UP
21
alternately, indicating that the
programming menu has been
accessed.
22 to scroll
through the different modifiable
parameters. Once the required
parameter is reached, press
button to change its values.
23
selected parameter, press buttons
and to reduce or increase
22 23
the values, respectively.
pressing a button, the system
saves the data and returns to its
initial setting.
NB! The PID system can be reset
for three
23
will show the
21
22
02/06/2022 8:53:58 02/06/2022 8:53:58