Publicidad
Idiomas disponibles
Idiomas disponibles
GB
NOTE The safety handle/operator presence
control does not lock in place. Hold it tight against
the handlebar during the entire working period.
Stopping the engine
1. Release the safety handle (09/2) or safety
bar (10/2). It automatically moves to its initial
position.
The engine stops immediately. The mower mech-
anism keeps running until it stops.
CAUTION! Danger of lacerations. There is
a danger of lacerations when reaching into the
mower mechanism while it is running on.
■
Wait until the mower mechanism has
stopped.
6.4
Mowing with grass collector (08)
The appliance can be operated with and without
grass collector.
Attaching the grass collector
1. Stop the motor (see chapter 6.3 "Starting and
stopping the motor (09 or 10)", page 25).
2. Raise the impact flap (08/1) (08/a).
3. Hook the grass collector (08/2) into the hold-
ers (08/b).
4. Release the impact flap.
Check the fill level (38.1 Li only)
The fill level indicator (11/1) is pressed upwards
by the air stream when mowing (11/a). If the
grass collector is full, the fill level indicator makes
contact with the grass collector. The grass collec-
tor must be emptied.
Removing and emptying the grass collector
CAUTION! Danger of lacerations. Danger
of lacerations when reaching into the running
mower mechanism.
■
Only remove the grass collector when the
mower mechanism has stopped.
NOTE When emptying the grass collector,
also clean the discharge holes of the fill level indi-
cator so they keep functioning properly.
1. Stop the motor (see chapter 6.3 "Starting and
stopping the motor (09 or 10)", page 25).
2. Raise the impact flap (08/1).
3. Lift the grass collector (08/2) out of the hold-
ers and take off to the rear.
4. Empty the grass collector.
26
5. Clean the exhaust holes of the fill level indi-
cator (11/2).
6. Attach the grass collector (see above).
7 WORK INSTRUCTIONS
Heed the safety instructions!
NOTE Comply with the local regulations as
to when a lawnmower can be operated.
■
Watch out for objects in the grass and re-
move them from the working area.
■
Only mow when visibility is good.
■
Only mow with a sharp cutting blade.
■
Only control the appliance by the handlebar.
■
Only move the appliance at walking speed.
■
Always move the appliance across the slope.
Do not mow up or down the slope, or on
slopes with a gradient of more than 10°. Ex-
ercise particular care when changing direc-
tion.
Cutting performance or operating time of the
rechargeable battery
■
The cutting performance or the area that can
be mown depends on the properties of the
grass. Factors such as the length of the
grass, the grass density, the selected cutting
height and wet grass affect the cutting perfor-
mance.
■
Optimum operating time is achieved by fre-
quent mowing and keeping the grass short.
■
Frequently switching the lawnmower on and
off during the mowing process reduces the
cutting performance as does a non-fully
charged rechargeable battery.
■
Starting the wheel drive reduces the cutting
performance or the operating time of the re-
chargeable battery.
■
To optimise cutting performance, it is recom-
mended to mow the grass often, to set a high
cutting height and to move the appliance at
walking speed.
NOTE To prolong the operating time, an ad-
ditional rechargeable battery can be purchased.
Tips for mowing
■
Maintain a constant cutting height of 3–5 cm;
do not mow the grass to less than half its
original height.
■
Do not overload the lawnmower. If the motor
speed drops noticeably because of long,
Work instructions
32.1 Li | 38.1 Li
Publicidad
